When it comes time to put your watch back together after removing a damaged or broken bezel fit watch crystal, you will find that a watch crystal press is an indispensible aide. Learn how to use a crystal press to fit a bezel fit crystal with this guide.
Tools Needed:
- A Selvyt cloth
- A Watch Crystal Press
- And a new watch crystal
Step 1
Before you can fit a new crystal to your watch case, you need to open the watch case and remove all the important parts of the movement to avoid damaging them and then measure the case to ensure that you have the right size replacement crystal.
Once you have removed the inner workings of the watch, and you have your new watch crystal in hand you will need to choose the watch press dies that fit the watch case appropriately to insert the crystal.
Step 2
Start by fitting one straight walled die to the back of your watch case – the part that usually sits against your wrist. The edges of the die should fit around the outer edges of the watch case without pressing on the watch lugs as it could bend and damage them.
When you have the correct size die for the back of your watch case, insert it into the watch crystal press on the bottom post that sticks up from the base.
Step 3
Next, you will need to find the die that will fit over the new watch crystal to position the metal bezel over it. You want to find the die with the straight walled die that will rest on the outer edges of the loose bezel ring but not touch the crystal under it. Holding the watch bezel in one hand, start fitting watch dies to it until you find the one with straight walls that sit on the edge of the bezel ring.
Position this second die in the watch crystal press on the top post of the press that faces down toward the other die you have already placed.
Step 4
Take your selvyt cloth and place it across the lower die to protect the back of the watch case from being scratched by the die. Place the watch case on the cloth covered lower die in the jaws of the watch case press with the top of the case facing up.
Step 5
Before you place the crystal over the watch case in the press, take the loose bezel and fit it over the top of the crystal and line up the edges. Once you have the crystal and bezel together, position them both over the opening in the top of the watch case, so the pressure will seal the bezel to the watch case and keep the crystal securely in place.
Step 6
Double check that the watch is positioned perfectly under the dies. Loosely close the jaws of the press to ensure the correct positioning. Grip the handle of the crystal press and slowly squeeze down bringing the two dies together. Apply a gentle amount of pressure until you hear the crystal click into place.
If the crystal bezel doesn’t slip into place quickly, check the crystal to be sure hasn’t been damaged before adding a little more pressure to it. Repeat this process, until you find the right amount of pressure to press the crystal into the watch case.
Finished
Once the crystal and bezel are in place, you can put your watch movement back together and then continue wearing your watch again. To learn how to place other watch types of watch crystals into a watch case, check out the rest of our Learning Center.
Hello,
will this press,
https://www.esslinger.com/watch-tool-crystal-press-and-case-closer-combination-w-aluminum-dies/
work for bezel fit crystal? I want to make sure before purchasing. thanks you
Hello Elliot, It could be used to fit bezels and crystals into bezels, but take precaution as using aluminum dies on a bezel runs the risk of scratching the bezel. The edges of the dies are smoothed to lower the risk of scratching but using a strong delrin die will be safer. Our Horotec presses offer the best quality and function when fitting a bezel.